The Modulift manufacturer is based in Somerset, UK.
No this will invalidate all Modulift Certification
We look at hires and rentals on a case-by-case basis. We do have strategically placed distributors all over the world that have the facility to hire our Spreader Beams and other Modulift products. Please see our Worldwide Distributor page for more information.
Yes. For all spreader beams up to 1500t capacity in accordance of with DNV’s standard for Certification No. 2.22 for Lifting Appliances 2011, at no extra cost to the client.
Each Modulift Spreader Beam series has been proof load tested in the Modulift compression test rig, and all products and been designed in accordance with international standards. These standards can be viewed on our Regulations and Standards page.
Yes we are able to provide paint in any Ral colour of your choice.
Grade 8.8 bolts, grade 8 nuts and form B washers.
No, our beams are designed for use in compression and have two lifting points at either end of the beam.
As standard our fixings and split pins (R Pins) are mild steel, which is detailed within our product User Instructions. Alternative materials can be specified to meet more specific requirements e.g. low temperature. However, stainless steel fixings are not offered, as they lack the strength and integrity required for lifting in relation to our products.
Each Modulift Spreader Beam series comes with its own user instructions. Torque settings can be found on page 1 of these instructions.
At Modulift we understand that organising a lift can be a complicated process with many factors that need to be considered. With our highly trained specialist lifting engineers, Modulift can help you with all your rig design needs. Send your lift details to email@example.com and we can advise the best solution for you.
Yes our spreader beams can be used inverted if you have a requirement for 2 lifting points on the top and 1 on the bottom. If you need any help with rig planning our team of design engineers can help you every step of the way. Contact Modulift on +44(0)1202 621511 or email firstname.lastname@example.org for more information.
No, our Spreader Beams are Modular and designed to be re-used at different spans therefore re-certification is not required.
Yes, with over 20 years experience Modulift’s team of design engineers are able to provide expert advice for all your lifting requirements. Whether you require a custom designed and engineered lifting solution, complex rig design, lifting products with high QA or a solution for a super heavy lift, Modulift is available every step of the way. Visit our Engineered Lifting Products page for more information and case studies on different porjects Modulift has worked on.
No, the Spreader Beams have to be used in accordance with Modulift user instructions.
We hold plenty of products in stock and we are able to offer next working day delivery to most UK addresses.
The maximum number of struts that can be used are 5 with two end units. The MOD 110 and MOD 110H are the only Modulift Spreader Beams that allows the use of 6 struts.
At Modulift we ensure legal and regulatory compliance, through internal and independent third party audits. In addition we comply with the recognised and respected global best practise, set out in the ISO Standards, through our Integrated Business Management System. Our commitment is to conduct our business consistent with the highest standards of social responsibility and ethics, which includes our supply chain. Our associated ethics and social responsibility Policies can be seen on our Regulations and Standards page.